no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.


—en:wifi [2025/08/31 23:18] (current) – created - external edit 127.0.0.1
Line 1: Line 1:
 +====== Wi-Fi ======
 +
 +
 +You can use a Wi-Fi connection to configure the device. By default, each device creates a closed access point. Access point access parameters (specified in the AP configuration)
 +
 +SSID: VM03_IMEI of device
 +Password: DVR + Last 3 digits + 4th and 5th one of IMEI
 +for example: IMEI 353464071592365
 +SSID: VM03_353464071592365
 +password: DVR36546
 +
 +----
 +
 +==== Wi-Fi and AP configuration ====
 +
 +
 +__Figure 1__ – Wi-Fi and AP configuration
 +
 +{{ :en:wifi_configuration.jpg?direct |}}
 +
 +__Table 1__ – Wi-Fi configuration parameter description
 +
 +^Parameter ^Parameter description^
 +|Wi-Fi mode |select the mode of operation of the Wi-Fi module|
 +|AP |access point|
 +|Client  |Connecting to an external access point|
 +|OFF |off|
 +|Hotspot SSID|The name of access point|
 +|Hotspot password|The password of access point|
 +
 +----
 +
 +==== Client configuration ====
 +
 +The device can transmit data to the server using a Wi-Fi network in connection mode to the access point. If you have a Wi-Fi connection, the default gateway will be switched from GSM to Wi-Fi, and all information will go via Wi-Fi. When you disconnect the Wi-Fi access point, you will be reconnected to GSM.
 +**ATTENTION! The connection to the access point should be set up after making sure that the signal level of the point is good.**
 +You can check the signal level on the Wi-Fi networks monitor tab. SIGNAL QUALITY of the required network must be at least 20%. If the network is spaced, or its level is below 20%, the module will switch to AR mode
 +
 +
 +__Figure 2__ – Client configuration
 +
 +{{ :en:wifi_configuration.jpg?direct |}}
 +
 +__Table 2__ – Client configuration parameter description
 +
 +^Parameter ^Parameter description^
 +|PR|Priority |
 +|SSID|Access point name|
 +|PWD|Access point password|
 +|NET|Connection status|
 +|Client management |Client configuration|
 +|Priority|Order of connection|
 +|SSID|Access point name|
 +|Password |Access point password|
 +|Internet test|Test internet connection|
 +
 +__Figure 3__ – Wifi information
 +
 +{{ :en:wifi_information.jpg?direct |}}
 +
 +__Table 3__ – Wifi information parameter description 
 +
 +^Parameter  ^Parameter description^
 +|STAT|The state of the client|
 +|SSID|Access point name|
 +|ADDR|Address of the client|
 +|MAC|Mac address of the client|
 +|Update data|Update network data |
 +|SSID|Access point name|
 +|SECUR|The type of Wi-Fi AP defense|
 +|MAC|Mac address of the Wi-Fi AP |
 +|Scan WiFi |Network Scanning|
 +|Raw info|Information about Wi-Fi AP  |
 +
 +To set the default settings, click the **Default** button. To save settings in NVR click **Save settings** button.