====== Wi-Fi ======


You can use a Wi-Fi connection to configure the device. By default, each device creates a closed access point. Access point access parameters (specified in the AP configuration)

SSID: VM03_IMEI of device
Password: DVR + Last 3 digits + 4th and 5th one of IMEI
for example: IMEI 353464071592365
SSID: VM03_353464071592365
password: DVR36546

----

==== Wi-Fi and AP configuration ====


__Figure 1__ – Wi-Fi and AP configuration

{{ :en:wifi_configuration.jpg?direct |}}

__Table 1__ – Wi-Fi configuration parameter description

^Parameter ^Parameter description^
|Wi-Fi mode |select the mode of operation of the Wi-Fi module|
|AP |access point|
|Client  |Connecting to an external access point|
|OFF |off|
|Hotspot SSID|The name of access point|
|Hotspot password|The password of access point|

----

==== Client configuration ====

The device can transmit data to the server using a Wi-Fi network in connection mode to the access point. If you have a Wi-Fi connection, the default gateway will be switched from GSM to Wi-Fi, and all information will go via Wi-Fi. When you disconnect the Wi-Fi access point, you will be reconnected to GSM.
**ATTENTION! The connection to the access point should be set up after making sure that the signal level of the point is good.**
You can check the signal level on the Wi-Fi networks monitor tab. SIGNAL QUALITY of the required network must be at least 20%. If the network is spaced, or its level is below 20%, the module will switch to AR mode


__Figure 2__ – Client configuration

{{ :en:wifi_configuration.jpg?direct |}}

__Table 2__ – Client configuration parameter description

^Parameter ^Parameter description^
|PR|Priority |
|SSID|Access point name|
|PWD|Access point password|
|NET|Connection status|
|Client management |Client configuration|
|Priority|Order of connection|
|SSID|Access point name|
|Password |Access point password|
|Internet test|Test internet connection|

__Figure 3__ – Wifi information

{{ :en:wifi_information.jpg?direct |}}

__Table 3__ – Wifi information parameter description 

^Parameter  ^Parameter description^
|STAT|The state of the client|
|SSID|Access point name|
|ADDR|Address of the client|
|MAC|Mac address of the client|
|Update data|Update network data |
|SSID|Access point name|
|SECUR|The type of Wi-Fi AP defense|
|MAC|Mac address of the Wi-Fi AP |
|Scan WiFi |Network Scanning|
|Raw info|Information about Wi-Fi AP  |

To set the default settings, click the **Default** button. To save settings in NVR click **Save settings** button.