This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== LAN configuration ====== __Figure 1__ – Chapter LAN configuration {{ :en:lan_configuration.jpg?direct |}} __Table 1__ – LAN configuration parameter description ^Parameter^Parameter description^ |Network type |Ethernet connection settings. Note that you need to use 10-100Base connectors and cables to connect via the Ethernet interface. When connected to a 1000Mbit network, the adapter may be damaged due to the twisted pair voltage transmission 12V interface| |Тип мережі|Статична адреса яку ви задаєте за замовчуванням (192.168.1.20) або ж DCHP| |IP address |IP address. To use the LAN as the Internet connection interface, the IP address must be different from 192.168.1.20 and the Gateway must be installed.| |Gateway |Default gateway | |Network mask|Allows to divide IP-address on two parts: number of network and number of device in this network.| |DCHP state|Choose the state of IP address of the connected to the mNVR devices: static or random | ---- ==== Scan LAN ==== {{ :en:lan_scanner.jpg?direct |}} LAN scanner allows to scan and find the devices your local network, to start the procedure press Start button, after scanning it will show the IP and MAC address of the device To set the default settings, click the **Default** button. To save settings in NVR click **Save settings** button.