This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== GSM ====== The device can transmit data to the server using a GSM connection. To connect to the GSM network you need a SIM card in MiniSIM format with support for 2G,3G, 4G. ---- ==== GSM/LTE traffic limits ==== __Figure 1__ – GSM/LTE traffic limits {{ :en:gsm_lte_traffic.jpg?direct |}} __Table 1__ – GSM information parameters description ^Parameter ^Parameter description ^ |Traffic limits |Restrictions on data transmission | |Limit |status on / off | |Daily(MB) |Daily transfer limit - removed at 00:01 the next day| |Mounthly(MB) |The monthly transfer limit is removed at 00:01 on the 01st day of the next day | |Daily/Monthly |statistics of GSM traffic used | |Upload to FTP |upload status to FTP | |Log |log statistics file | ---- ==== GSM/LTE configuration ==== __Figure 2__ – GSM/LTE configuration {{ :en:gsm_lte_configuration.jpg?direct |}} ^Parameter ^Parameter description ^ |Default SIM holder|Choosing type of SIM holder, upper – metallic, is located inside the side cover window, and lower – plastic, which located on the bottom of the plate(to insert SIM into lower SIM holder you need to disassemble device)| |Wireless network mode|The modes of operation of mobile network, choose AUTO for automatic settings |APN|Access point| ---- ==== Standard APN of Ukraine and dialing numbers ==== __ Table 3__ – Standard APN of Ukraine and dialing number {{ :en:apn.jpg?direct |}} ---- ==== SMS/USSD configuration==== __Figure 3__ - SMS/USSD configuration {{ :en:sms_ussd.jpg?direct |}} __Table 4__ - GSM/LTE configuration parameter description ^Parameter ^Parameter description^ |SMS control numbers|Your SIM card number | |Send custom SMS|Send an SMS to your SIM card number which you will need to enter in the field on the right| |Send USSD|Send the USSD code to your SIM card number which you will need to enter in the field on the right| To set the default settings, click the **Default** button. To save settings in NVR click **Save settings** button.